2013-03-29 13:56:27 Click:
Dehumidifier works
Drying is a method used to heat the material to pass water, and leaving the heat as the latent heat of evaporation, separation of manipulating `drying process can be divided into three phases: warm-up phase of the material, the constant speed phase, and spin-down phase. Because the physical properties of different materials, the material is divided into surface water, water, internal water, bound water, crystal water, because water is not the same form of dryer is divided into a lot of different types of principles.
Currently being used along with a wide range of engineering plastics, desiccant-type dryer has slowly replaced the traditional hot-air dryer (oven), the use of dryers, will bring the following four benefits:
1, can be taken away plastic raw materials in the water to eliminate air bubbles, so that products meet very good mechanical, electrical, dimensional chaos with the appearance of smooth and beautiful;
2, to prevent the production of defective products and return loss, greatly reducing waste generation;
3, because the desiccant dryer is the use of very dry air into the line of dehumidifiers to work, so the material can greatly reduce the drying time, saving hours of work, you create more profit;
4, desiccant air dryer cycle system pipe are sealed and equipped with a filter, so free from outside the climate, as well as to prevent dust pollution in the factory, you create a gentle environment.